Why does using Stabilization Damping Factor not give the the same force result if you are in US unit system or if you are in SI unit system?
March 17, 2023 at 9:00 amFAQParticipant
When you change the unit system of a first analysis which use the stabilize method the value of the energy is not changed. Before running the second analysis with the new unit system, you need to change the value of the energy manually in order to have the same results. The following statement has been added at 15.0 to clairify this scenario: When Damping is specified, a Damping Factor value needs to be entered. The damping factor is the value that the ANSYS solver uses to calculate stabilization forces for all subsequent substeps. This value is greater than 0. Note: The Damping Factor value is dependent on the active unit system and may influence the results if unit systems are changed. You may wish to use an initial trial value from a previous run for this entry (such as a run with the Energy Dissipation Ratio as input). See the Controlling the Stabilization Force section of the Mechanical APDL Structural Analysis Guide for additional information.
Introducing Ansys Electronics Desktop on Ansys Cloud
The Watch & Learn video article provides an overview of cloud computing from Electronics Desktop and details the product licenses and subscriptions to ANSYS Cloud Service that are...
How to Create a Reflector for a Center High-Mounted Stop Lamp (CHMSL)
This video article demonstrates how to create a reflector for a center high-mounted stop lamp. Optical Part design in Ansys SPEOS enables the design and validation of multiple...
Introducing the GEKO Turbulence Model in Ansys Fluent
The GEKO (GEneralized K-Omega) turbulence model offers a flexible, robust, general-purpose approach to RANS turbulence modeling. Introducing 2 videos: Part 1 provides background information on the model and a...
Postprocessing on Ansys EnSight
This video demonstrates exporting data from Fluent in EnSight Case Gold format, and it reviews the basic postprocessing capabilities of EnSight.
- The LS-DYNA equivalent of *MODEL_CHANGE card (in ABAQUS). Which keywords can be used to introduce(activate)/delete(deactivate) elements in the middle of a calculation (at user-specific time/load steps).
- The warning message is: “The maximum contact stiffness is too big. This may affect the accuracy of the results.” Why does large contact stiffness affect results accuracy?
- Contact Definitions in ANSYS Workbench Mechanical
- How to deal with “”Problem terminated — energy error too large””?”
- After Workbench crashes, how can I recover the project from a .mechdb file?
- How to display the color of each body based on the material in Mechanical?
- How to resolve “Error: Invalid Geometry”?
- Model has a large number of contacts – how to reduce them?
- Please explain the difference between Point Mass and Distributed Mass.
- How to locate an element of a particular ID number in Mechanical?