-
-
January 31, 2023 at 8:55 am
FAQ
Participant金型を使用した接触問題で、流体が金型をすり抜ける場合、”penalty coefficient”※の値をデフォルトより(デフォルト1e9)大きく設定してください。 (2021R1からデフォルトが1e12に変更されています) ※ “penalty coefficient”は垂直方向の反力の係数です。 この値を小さくすると接触反力が弱くなり金型を貫通しやすくなります。大きくすると貫通しにくくなります。 また、時間刻みや初期の接触距離でも金型をする抜けることがあります。
-

Introducing Ansys Electronics Desktop on Ansys Cloud
The Watch & Learn video article provides an overview of cloud computing from Electronics Desktop and details the product licenses and subscriptions to ANSYS Cloud Service that are...

How to Create a Reflector for a Center High-Mounted Stop Lamp (CHMSL)
This video article demonstrates how to create a reflector for a center high-mounted stop lamp. Optical Part design in Ansys SPEOS enables the design and validation of multiple...

Introducing the GEKO Turbulence Model in Ansys Fluent
The GEKO (GEneralized K-Omega) turbulence model offers a flexible, robust, general-purpose approach to RANS turbulence modeling. Introducing 2 videos: Part 1 provides background information on the model and a...

Postprocessing on Ansys EnSight
This video demonstrates exporting data from Fluent in EnSight Case Gold format, and it reviews the basic postprocessing capabilities of EnSight.
- STLファイルのエクスポートは可能ですか?
- エラーメッセージ:Signal caught: Abnormal termination について
- Mesh Interfaceで周期境界を設定する方法
- resファイルからモニターデータをcsvで出力する方法
- CFD-POSTで、最大値と最小値の場所を表示する方法は?
- MSMD Battery Model 短絡のモデル化について
- Fluentでのcasとdatファイルの読み込み注意点
- Windowsでバックグラウンド実行時Fluentソルバーの停止とファイル保存
- 境界条件をコピーする際の注意点
- フェイスがwallかどうかを判別する方法
© 2023 Copyright ANSYS, Inc. All rights reserved.