I applied two remote forces to one face and got this warning message: “Two or more remote boundary conditions are sharing a common face, edge, or vertex. This behavior can cause solver overconstraint and is not recommended, please check results carefully.”
June 6, 2022 at 9:58 amFAQParticipant
Remote points are attached to the geometry through constraints equations (CE). This defines coupling between the dofs of the remote point and the dofs of nodes of the scoped geometry. However, each node can only be coupled once : if a node of the geometry is scoped to two or more remote points/forces, this causes overconstraint and the solver will delete one set of CE to relieve the overconstraint. Thus the warning message to inform the user. A method is to create a remote point scoped to the face first and then define the two remote forces by scoping them to the remote point.
Introducing Ansys Electronics Desktop on Ansys Cloud
The Watch & Learn video article provides an overview of cloud computing from Electronics Desktop and details the product licenses and subscriptions to ANSYS Cloud Service that are...
How to Create a Reflector for a Center High-Mounted Stop Lamp (CHMSL)
This video article demonstrates how to create a reflector for a center high-mounted stop lamp. Optical Part design in Ansys SPEOS enables the design and validation of multiple...
Introducing the GEKO Turbulence Model in Ansys Fluent
The GEKO (GEneralized K-Omega) turbulence model offers a flexible, robust, general-purpose approach to RANS turbulence modeling. Introducing 2 videos: Part 1 provides background information on the model and a...
Postprocessing on Ansys EnSight
This video demonstrates exporting data from Fluent in EnSight Case Gold format, and it reviews the basic postprocessing capabilities of EnSight.
- Does ECAD trace mapping support more than one type of trace material (usually copper) in the same layer?
- ANSYS Mechanical: Fatigue Crack Growth Analysis using SMART Crack Growth
- How to define frictional coefficient as a function of relative sliding velocity
- How can I understand Beam Probe results?
- Can the contact type (bonded or frictional) affect thermal results?
- What is the difference between secant and instantaneous coefficients of thermal expansion (CTE)?
- What does ambient temperature represent when using surface to surface radiation?
- What is pinball radius and does mesh size effect this value?
- Which time integration scheme is used in transient thermal analysis and how to change the scheme?
- Static Structural Analysis of a Rear Upright – Part 1