-
-
April 5, 2023 at 2:31 pm
FAQ
ParticipantDecreasing voxel size can increasing the solution run time exponentially to the power of 4 (assuming uniform part, like a cube). As an example if the initial voxel size took 5 minutes of run time, and then the voxel size was reduced by half the run time could approximately be expected to increase to 5*(1/0.5)^4 = 80 minutes. Currently voxel size is limited between 0.02mm and 2mm. However, due to memory requirements of smaller voxel size simulations this range of voxel size is not guaranteed to finish the simulation.
-

Introducing Ansys Electronics Desktop on Ansys Cloud
The Watch & Learn video article provides an overview of cloud computing from Electronics Desktop and details the product licenses and subscriptions to ANSYS Cloud Service that are...

How to Create a Reflector for a Center High-Mounted Stop Lamp (CHMSL)
This video article demonstrates how to create a reflector for a center high-mounted stop lamp. Optical Part design in Ansys SPEOS enables the design and validation of multiple...

Introducing the GEKO Turbulence Model in Ansys Fluent
The GEKO (GEneralized K-Omega) turbulence model offers a flexible, robust, general-purpose approach to RANS turbulence modeling. Introducing 2 videos: Part 1Â provides background information on the model and a...

Postprocessing on Ansys EnSight
This video demonstrates exporting data from Fluent in EnSight Case Gold format, and it reviews the basic postprocessing capabilities of EnSight.
- The warning message is: “The maximum contact stiffness is too big. This may affect the accuracy of the results.” Why does large contact stiffness affect results accuracy?
- Contact Definitions in ANSYS Workbench Mechanical
- After Workbench crashes, how can I recover the project from a .mechdb file?
- Model has a large number of contacts – how to reduce them?
- How to resolve “Error: Invalid Geometry”?
- How to display the color of each body based on the material in Mechanical?
- How to deal with “”Problem terminated — energy error too large””?”
- The LS-DYNA equivalent of *MODEL_CHANGE card (in ABAQUS). Which keywords can be used to introduce(activate)/delete(deactivate) elements in the middle of a calculation (at user-specific time/load steps).
- How to locate an element of a particular ID number in Mechanical?
- Please explain the warning message “coefficient ratio exceeds 10e8” ?
© 2023 Copyright ANSYS, Inc. All rights reserved.