-
-
January 31, 2023 at 8:55 am
FAQ
ParticipantCFD-POSTではある面で拘束された流線を描く事が可能です。 具体的な手順としては以下のとおりです。 (1)TypeからSurface Streamlineを選択 (2)Surfaceから拘束したい面を選びます(この例ではPlan 1を選択。Plan 1の位置は下図を参照)。 (3)Start FromからLocationsを選択 (4)Locationsから流線を出す位置を選びます(この例ではinlet 1を選択。inlet 1の位置は下図を参照)。 なお、Plan 1に拘束させずにinlet 1から流線を描くと下記の図のようになります(このときTypeは3D Streamlineを選択します)。 詳細は添付PDFを参照ください。
-

Introducing Ansys Electronics Desktop on Ansys Cloud
The Watch & Learn video article provides an overview of cloud computing from Electronics Desktop and details the product licenses and subscriptions to ANSYS Cloud Service that are...

How to Create a Reflector for a Center High-Mounted Stop Lamp (CHMSL)
This video article demonstrates how to create a reflector for a center high-mounted stop lamp. Optical Part design in Ansys SPEOS enables the design and validation of multiple...

Introducing the GEKO Turbulence Model in Ansys Fluent
The GEKO (GEneralized K-Omega) turbulence model offers a flexible, robust, general-purpose approach to RANS turbulence modeling. Introducing 2 videos: Part 1 provides background information on the model and a...

Postprocessing on Ansys EnSight
This video demonstrates exporting data from Fluent in EnSight Case Gold format, and it reviews the basic postprocessing capabilities of EnSight.
- STLファイルのエクスポートは可能ですか?
- エラーメッセージ:Signal caught: Abnormal termination について
- Mesh Interfaceで周期境界を設定する方法
- resファイルからモニターデータをcsvで出力する方法
- CFD-POSTで、最大値と最小値の場所を表示する方法は?
- MSMD Battery Model 短絡のモデル化について
- Fluentでのcasとdatファイルの読み込み注意点
- Windowsでバックグラウンド実行時Fluentソルバーの停止とファイル保存
- 境界条件をコピーする際の注意点
- フェイスがwallかどうかを判別する方法
© 2023 Copyright ANSYS, Inc. All rights reserved.